Cub Cadet 435A Spécifications télécharger pdf (Page 64)

RZT-S

Drag links

To remove/replace a drag link:

1. Remove the floor pan by following the procedures

described in Chapter 3: Body.

2. Turn the steering wheel so that the drag links outer

ball joint is accessible through the opening if the

frame. See Figure 5.25.

3. Loosen the both the inner and outer drag link ball

joint jam nuts using a 9/16” wrench.

4. Remove the outer ball joint using a pair of 9/16”

wrenches.

5. Turn the steering wheel to bring the sector gears to

the center (neutral) position.

NOTE: Install the 1/4” alignment pin to insure that

the sector gears are in the neutral position.

See Figure 5.26.

6. Disconnect the inner drag link ball joint from the

sector gear using a pair of 9/16” wrenches.

Figure 5.25

outer ball joint

Figure 5.26

1/4” alignment pin

www.mymowerparts.com

For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 135 136

Pas de commentaire

Cub Cadet 435A Spécifications Page 64