Cub Cadet GT 2554 Manuel de l'opérateur télécharger pdf (Page 40)

8. Loosen the upper jam nut on the lift link rod and

turn away from the adjustment ferrule. Turn the

lower lock nut upward (tighten) on the threads of

the rod to raise the right side of the mower deck.

Turn the lock nut down (loosen) on the threads to

lower the right side of the mower deck (See Figure

52).

Figure 52

9. Raise the lift handle to the highest position and

recheck the blade measurements described in

step 5. If the blade measurements are not within

1/16 inch, repeat steps 6, 7 and 8.

10. Tighten the upper jam nut against the adjustment

ferrule after side-to-side leveling is completed.

FRONT TO BACK LEVELING ADJUSTMENT

1. Raise the deck to its highest position.

2. If making the initial installation of the deck, adjust

the front lift rod to allow 5/8 inch of thread to

protrude beyond both lock nuts of the front lift rod/

bracket assembly (See Figure 53).

Figure 53

3. Position the mower blades so the ends of each

blade point to the front and the rear of the tractor

(See Figure 54).

Figure 54

4. Refer to Figure 55. Measure and record the

distance from the front cutting edge to the ground

(measurement A), and from the rear cutting edge

to the ground (measurement B), for each of the

blades. The front edge of each blade

(measurement A) should be lower than its back

edge (measurement B) by 1/8 to 1/4 inch.

Figure 55

5. Lower the deck onto the hard, level surface.

6. To adjust the downward tilt of the blades,

adjustment of the front lift rod is required. Refer to

Figure 53 and proceed as follows:

7. Loosen the rear jam nuts on the front lift rod. From

the front of the tractor, turn the front lock nuts

clockwise to raise the front of the mower deck, or

counterclockwise to lower the front of the mower

deck.

RIGHT HAND

LIFT LINK ROD

UPPER

JAM NUT

ADJUSTABLE

FERRULE

LOWER

LOCK NUT

FRONT

LIFT ROD

JAM NUT

LOCK NUT

FRONT LIFT

ROD BRACKET

5/8"

DECK

INSTALLED

MOWER

BLADES

FRONT

CUTTING

EDGE

REAR

CUTTING

EDGE

CUTTING BLADE

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet GT 2554 Manuel de l'opérateur Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Tracteur Cub Cadet GT 2554