Cub Cadet LTX 1042 KW Manuel de l'opérateur télécharger pdf (Page 25)

Remove the cotter pin from the end of the stabilizer rod 

and slide the stabilizer out of the hanger bracket on the



Gently slide the cutting deck (from the right side) out from  

underneath the tractor.

Changing the Deck Belt

WARNING! The V-belts found on your tractor are

specially designed to engage and disengage safely.



not disengaging completely. For a proper working

machine, use factory approved belts.

All belts on your tractor are subject to wear and should be

replaced if any signs of wear are present. To change or replace

the deck belt on your tractor, proceed as follows:

Remove the deck as instructed on page 24.

Remove the belt covers by removing the hex washer 2.



6.



7.

Move the deck lift lever into the top notch to raise the deck 8.

lift arms up and out of the way.

Carefully remove the deck engage cable from the rear of 

the cutting deck by removing the bow-tie cotter clip that

secures it. Remove the spring from the deck idler bracket.



Deck Lift

Arm

Deck Support

Figure 7-3

Figure 7-5

Figure 7-4

Hex Washer Screws

Belt Cover

Deck Idler Pulley

Spindle Pulley

Belt Guard

Figure 7-6

25se c t i O n 7 — se r v i c e

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Cub Cadet LTX 1042 KW Manuel de l'opérateur Page 25