Cub Cadet LTX 1042 KW Manuel de l'opérateur télécharger pdf (Page 23)

Leveling the Deck (Side to Side)

If the cutting deck appears to be mowing unevenly, a side to side

adjustment can be performed. Adjust if necessary as follows:

With the tractor parked on a firm, level surface, place the 

deck lift lever in the middle position and rotate both blades

so that they are perpendicular with the tractor.

Measure the distance from the outside of the left blade 2.

tip to the ground and the distance from the outside of the









Using a wrench, raise or lower the left side of the deck by 4.



The deck is properly leveled when both blade tip measurements

taken earlier are equal. Retighten the hex bolt on the left deck

hanger bracket when proper adjustment is achieved.

Parking Brake Adjustment

If the tractor does not come to a complete stop when the brake



roll with the parking brake applied (and the transmission relief



Cadet dealer to have the brake properly adjusted.

Adjusting the Seat



adjustment instructions.

WARNING! 

the seat is engaged in the seat-stop. Engage the



back on seat until it clicks into place.

Steering Adjustment

If the tractor turns tighter in one direction than the other, or if

the ball joints are being replaced due to damage or wear, the

steering drag links may need to be adjusted.

Adjust the drag links so that equal lengths of each are threaded

into the ball joint on the left side and the ball joint on the right

side:



Thread the ball joint inward to shorten the drag link. 2.

Thread the ball joint outward to lengthen the drag link.

Replace the hex nut after proper adjustment is achieved.

NOTE: Threading the ball joints too far onto the drag links



between ⁄⁄

Front tire toe-in can be measured as follows:4.

a.

ahead travel.

In front of the axle, measure the distance b.

horizontally from the inside of the left rim to the

inside of the right rim. Note the distance.

c.

from the inside of the left rim to the inside of the

right rim. Note the distance.

The measurement taken in front of the axle should be 5.

between ⁄⁄

behind the axle.

Hex Bolt

Adjustment

Gear

Figure 6-6

Hex Nut

Drag Link

Ball Joint

Figure 6-7

23se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet LTX 1042 KW Manuel de l'opérateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Cub Cadet LTX 1042 KW