Cub-cadet P Series Manuel d'utilisateur télécharger pdf (Page 65)

60 PJ Series

Refer to Figure 6.

Perform disassembly, inspection and assembly on

check valves one side at a time. Some units vary in

“A” side to “B” side check configuration.

Disassembly

1. Remove the check valve (42) with an 1/4” allen

wrench.

2. Remove the valve spring and poppet from the

end cap.

Inspection

1. Inspect the poppets and mating seats in the end

cap for damage or foreign material.

Assembly

1. Lay the pump on its side, so the check plug port

is horizontal.

2. Insert the check plug, spring and poppet (42) as

one assembly into the check plug port. Tighten,

reference Table 2, page 56 for torque values.

3. Repeat disassembly, inspection and assembly

for the opposite port side.

REMOVAL, INSPECTION AND/OR

REPLACEMENT OF CHECK VALVES

REMOVAL, INSPECTION AND/OR

REPLACEMENT OF SYSTEM CHECK

RELIEFS (SCR’S) OR SHOCK

VALVES

Refer to Figure 7.

Disassembly

Perform disassembly, inspection and assembly on

SCR/shock valve one side at a time. Some units

vary in “A” side to “B” side configuration.

1. Remove the SCR (42) with a 7/8” wrench or the

shock valve (42) with an 11/16” wrench.

2. Remove the check relief/shock valve spring and

the check relief/shock valve from the end cap.

Inspection

1. Inspect the check relief or shock valve (42) and

mating seat in the end cap for damage or foreign

material.

Assembly

1. Lay the pump on its side, so the check plug port

is horizontal.

2. Insert the system check relief spring and check

relief or shock valve spring and shock valve as

one assembly into the check plug port. Tighten

to the correct torque value. See page 56.

3. Repeat disassembly, inspection and assembly

for the opposite port side.

Figure 6. PJ Pump Check Valves

Figure 7. PJ Pump Shock Valves

42A

42B

42A

42B

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 135 136

Commentaires sur ces manuels

Pas de commentaire

Cub-cadet P Series Manuel d'utilisateur Page 65

Commentaires sur ces manuels