Cub-cadet P Series Manuel d'utilisateur télécharger pdf (Page 31)

26 PC Series

Refer to Figure 6.

Perform disassembly, inspection and assembly on

shock valve one side at a time. Some units vary in

“A” side to “B” side configuration.

Disassembly

1. Remove the shock valve (42) with an 11/16-inch

wrench.

2. Remove the shock valve spring and the shock

valve from the end cap.

Inspection

Inspect the shock valve (42) and mating seat in the

end cap for damage or foreign material.

Assembly

1. Position the pump so the shock valve port is

horizontal.

2. Insert the shock valve spring and shock valve

as one assembly into the check plug port. Tighten

to the correct torque value. See Table 2, page

22 (Torque Values).

3. Repeat disassembly, inspection and assembly

for the opposite port.

REMOVAL, INSPECTION AND/OR

REPLACEMENT OF SHOCK VALVES

REMOVAL, INSPECTION AND/OR

REPLACEMENT OF THE BYPASS

Refer to Figure 7.

Disassembly

1. Loosen the bypass valve (15) using a 7/16-inch

wrench.

2. Remove the bypass (15) from the end cap.

Inspection

1. Inspect the bypass O-rings and mating seats in

the end cap for damage or foreign material.

2. If damaged or worn, replace bypass (15).

Assembly

1. Position the pump so the bypass port is

horizontal.

2. Insert the bypass (15) into the bypass port of

the end cap. Tighten to the correct torque value.

See Table 2, page 22 (Torque Values).

Figure 6. PC Pump Shock Valves

Figure 7. PC Pump Bypass

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 135 136

Pas de commentaire

Cub-cadet P Series Manuel d'utilisateur Page 31