Cub Cadet 440 Manuel de l'opérateur télécharger pdf (Page 22)

Removing or installing blades

If the mower blades need to be removed, do the following:

1. The blade turns in a counter clockwise direction when viewed from the bottom

of the deck. The cutting edge must be towards the direction of rotation. The lift

wing of the blades is closest to the deck and the cutting edge away from it (see

fig. 11).

2. Install the cup washer (see fig. 11) over the blade bolt and secure the blade in

place as described above.

3. With a wrench, block the spindle and tighten the bolt to 103 lb.ft. (see fig. 12).

4. To remove the blades reverse the procedure.

WARNING: Do not substitute blades or any bolt for the blade retaining bolt.

Company blades and blade retaining bolts are specially made for this application.

Using non original parts can effect the quality of cut and may also cause damage

to the mower.

FM48/FM60/FM72 OPERATOR’S MANUAL

MAINTENANCE 22 CUB CADET YANMAR

Ground

Fig. 11

1. grease fitting

2. hexagonal nut

3. pulley

4. rotor support

5. cover

6. shaft

7. blade

8. cup washer

9. blade bolt

10. cutting edge close to ground

11. lift wing

Mower's spindle assembly.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 51 52

Pas de commentaire

Cub Cadet 440 Manuel de l'opérateur Page 22