Cub Cadet 190-002 Manuel de l'opérateur

IMPORTANT: Read safety rules and instructions carefully before operating equipment.CUB CADET CORP. P.O. BOX 368023 CLEVELAND, OHIO 44136-9722Model 190

10IMPORTANT: If working on or with the battery for any reason, disconnect the NEGATIVE (Black) wire from it’s terminal first, followed by the POSITIVE

11• To mark the hole to ensure proper centering of the new hole to be drilled, place the pointed end of a center punch on the cross hairs of new hole

12SECTION 7: MOUNTING THE TILLERInstalling the Attachment HitchThe attachment hitch, which has the electric lift cylinder attached to it, attaches to

13Attaching the Hydraulic Pump AssemblyTo mount the hydraulic pump assembly to the tractor, make certain that it is placed under the center of the tra

14SECTION 8: KNOW THE TILLERFigure 14Lift SwitchThe lift switch is located on the right side of the steering wheel on the dash panel and is used to r

15R is the reverse tilling position. The tine direction lever is pushed toward the back of the machine, or away from the operator to start the tines i

16Engaging the Tiller NOTE: Refer to the tractor’s operator’s manual forinformation concerning starting and stopping thetractor, and location and pro

17For shallow tilling, drop the roller to its lowest position by putting the locking rod into the highest hole of the adjustment bar. For deeper tilli

18If the object does not dislodge using this method and the tines continue to not spin:• Shut off the PTO immediately, shift the tine direction lever

19With the new filter in place, remove all tools used to change the filter from the tiller: • Start the tiller in motion for about one minute in order

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices... 3Slope Gauge ...

20Replace only one tine at a time. This will help to insure the correct positioning of the tines as they are mounted on the tine assembly. When instal

21SECTION 11: STORAGENOTE: Before removing the tiller attachment forstorage, perform all lubrication maintenance as outlinedin the Maintenance secti

22Figure 25• Holding the hitch latches up will allow the tractor, with the attachment hitch still mounted, to be pushed away from the tiller with the

23SECTION 13: TEMPLATESDash Panel TemplateInstructions:1. Carefully cut the template along the dotted lines only.2. Tape the template into position o

24

25Rear Frame TemplateExisting HoleInstructions:1. Carefully cut the template along the dotted lines only.2. Continue following instruction given on pa

MANUFACTURER’S LIMITED WARRANTY FOR:TWO-YEAR RESIDENTIALONE-YEAR COMMERCIALProper maintenance of your Cub Cadet equipment is the owner’s responsibilit

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESWARNING: This symbol points out important safety instructions which, if not followed, could endanger th

4parking brake, turn engine off and remove key before dismounting.• Disengage the PTO, stop the engine and wait until the tiller comes to a complete s

5• Never remove gas cap or add fuel while the engine is hot or running. Allow engine to cool at least two minutes before refueling.• Never over fill f

6SECTION 2: SLOPE GAUGE

7SECTION 3: TO THE OWNERModel 190-002-100, 30-inch hydraulic tiller attachment is designed for use on Series 2000 Lawn Tractors with 23” rear tires o

8To connect the hydraulic hoses to the hydraulic pump assembly:• Locate both male hydraulic fittings on the hydraulic pump. Notice that the fittings a

9SECTION 6: PREPARING THE TRACTORNOTE: References to LEFT and RIGHT indicate the leftand right sides of the tractor and tiller attachment whenfacing