ENGINE
6-46 TNV IDI Service Manual
Cylinder Block
11. Remove the crankshaft from the engine.
12. Remove the bearing inserts (Figure 6-59, (1))
and thrust bearings (Figure 6-59, (2)).
Note: Do not remove the crankshaft gear
unless the gear or crankshaft are
damaged and require replacement.
Figure 6-59
13. If necessary, remove the crankshaft gear
(Figure 6-60, (1)) and key (Figure 6-60, (2)). If
using a gear puller, be careful not to damage
the threads in the end of the crankshaft.
Figure 6-60
Inspection of Crankshaft and
Camshaft Components
Thoroughly clean all components using a brush
and appropriate solvent. Each part must be free of
carbon, gasket material, metal filings and other
debris.
Note: Record all measurements taken during
inspection.
Replacement of Crankshaft Oil Seals
1. Remove the seal (Figure 6-61, (2)) from the
gear case cover (Figure 6-61, (1)).
2. Apply a continuous bead of ThreeBond Liquid
Gasket No. 1212, Yanmar Part No.
977770-01212 to the outside diameter of a new
oil seal (Figure 6-61, (2)).
3. Install a new seal in the gear case cover with
the lip facing in away from the crankshaft pulley.
Apply lithium grease to the lip of the seal.
A WARNING
FUME / BURN HAZARD!
• Always read and follow safety related
precautions found on containers of
hazardous substances like parts
cleaners, primers, sealants and
sealant removers.
• Failure to comply could result in death
or serious injury.
0000014en
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 46 ページ 2007年11月29日 木曜日 午後2時58分
Commentaires sur ces manuels