Cub-cadet Yanmar 3TNV72 Manuel d'utilisateur télécharger pdf (Page 247)

ALTERNATOR

11-14 TNV IDI Service Manual

Alternator

9. Remove the stator assembly

(Figure 11-10, (1)) from the front frame

housing.

Figure 11-10

10. If it is necessary to replace the bearing

(Figure 11-10, (2)) in the front frame housing,

remove the four bolts (Figure 11-10, (3))

securing the plate (Figure 11-10, (4)) to the

front frame housing. Remove the plate. Use a

puller to remove the bearing. Discard the

bearing.

11. If it is necessary to replace the bearing

(Figure 11-11, (1)) in the rear frame housing,

use a puller to remove. Discard the bearing.

Remove the bearing cover (Figure 11-11, (2))

and two thrust washers (Figure 11-11, (3)).

Figure 11-11

Reassembly of Alternator

1. If removed, reinstall the two thrust washers

(Figure 11-12, (3)) and bearing cover

(Figure 11-12, (2)) in the rear frame housing.

Lubricate the outside diameter of a new bearing

(Figure 11-12, (1)). Press the bearing into the

rear frame housing.

Figure 11-12

2. If removed, lubricate the outside diameter of a

new front frame housing bearing. Press the

bearing (Figure 11-13, (2)) into the front frame

housing. Reinstall the plate (Figure 11-13, (4))

to the front housing. Tighten the four bolts

(Figure 11-13, (3)).

Figure 11-13

0000259A

0000260A

0000259A

TNV_IDI_ServiceManual_(3TNV72 for YN only).book 14 ページ２００７年１１月２９日　木曜日　午後２時５８分

1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 282 283

Pas de commentaire

Cub-cadet Yanmar 3TNV72 Manuel d'utilisateur Page 247