Cub-cadet GT-2550 Manuel d'utilisateur télécharger pdf (Page 40)

IMPORTANT: Gauge wheels are intended to prevent

scalping of the lawn, and are not designed to be used

to set the cutting height. Do not run the deck on the

gauge wheels.

To adjust the height of the gauge wheels, place the

tractor on a firm and level surface. Refer to Figure 51,

and proceed as follows:

1. Place the tractor implement lift handle in the

normally desired mowing height setting, then

check the gauge wheels for contact or excessive

clearance with the surface below.

2. If the wheels contact the surface adjust as follows:

a. Raise the implement lift handle to its highest

setting.

b. Remove the rear gauge wheels by removing

the lock nuts and shoulder screws. Remove

the lock nuts and shoulder screws fastening

the front ball wheels to the deck gauge wheel

brackets.

Figure 51

c. Again place the tractor implement lift handle in

the normally desired mowing height setting.

d. Insert the shoulder screw with the rear gauge

wheel into the adjustment index hole that pro-

vides approximately 1/2" clearance between

the wheel and level surface. Secure with the

lock nut.

e. Note the position of the index hole used; then

install the other rear gauge wheel and the front

ball wheels into the corresponding index hole

of the other gauge wheel brackets.

3. If the gauge wheels have excessive clearance with

the surface below, lower the wheels to the index

hole that provides the approximate 1/2" clearance

as described above.

IMPORTANT: All gauge wheels shoud be installed in

the same relative adjustment index hole location in

each of the gauge wheel brackets.

CUTTING HEIGHT ADJUSTMENT

The mower can be set in multiple positions. Proceed

as follows:

NOTE: If multiple positions are used while mowing, it

may be necessary to adjust the gauge wheels for each

setting to prevent scalping.

1. Push the tractor implement lift handle down slightly

and depress the button on the top of the lift handle.

2. Raise or lower the lift handle to obtain the desired

mower deck cutting height.

3. Release the button when the desired mower

position is obtained.

NOTE: To return the mower deck to a specific position,

note the position of the lift lever before raising or

lowering the mower deck.

C. MAINTENANCE

BLADE CARE

WARNING: Before performing any main-

tenance, place the PTO switch in the

“OFF” position, engage the parking

brake, turn the ignition key to the “OFF”

position and remove the key from the

switch to avoid accidental starting and

injury. When servicing the mower deck,

be careful not to cut yourself on the

sharpened blades.

The cutting blades must be kept sharp at all times.

IMPORTANT: Sharpen the cutting edges of the blades

evenly so that the blades remain balanced and the

same angle of sharpness is maintained.

If the cutting edge of a blade has already been sharp-

ened many times, or if any metal separation is present,

it is recommended that new blades be installed. New

blades are available at your authorized dealer.

SHOULDER

SCREWS

FRONT BALL

WHEEL

GAUGE

WHEEL

BRACKET

ADJUSTMENT

HOLES

LOCK

NUT

LOCK

NUT

REAR

WHEEL

GAUGE

WHEEL

BRACKET

INDEX

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Cub-cadet GT-2550 Manuel d'utilisateur Page 40

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Cub-cadet GT-2550