Cub-cadet GT-2550 Manuel d'utilisateur télécharger pdf (Page 20)

SECTION III. ADJUSTMENTS

This section contains information for the various

adjustments on the tractor. Adjustment information for

the mower deck is located in Section V – Mower Deck.

ADJUSTING THE SEAT

WARNING: Do not adjust the seat when

the tractor is moving. Adjusting the seat

while the tractor is moving could cause

the operator to lose control of the tractor.

Both seat arm rests can be rotated upward for mount-

ing and dismounting the tractor, or for the personal

comfort of the operator.

Before starting the tractor, adjust the seat forward or

rearward to the most comfortable driving position. To

reposition the seat, move the seat adjustment lever

(See Figure 11) toward the left and slide the seat

forward or rearward. Release the adjustment lever

when the seat is comfortably positioned. Gently rock

the seat forward or rearward to be sure the seat is

locked in place.

Figure 11

ADJUSTING THE BRAKES

During normal operation of this tractor, the brakes are

subject to wear and will need periodic examination and

adjustment.

To check the brake adjustment, position the tractor on

a firm and level surface. Stop the tractor engine and

remove the ignition key. Pull and lock the transmission

release lever in the “TRANSMISSION RELEASED”

position. Perform the following checks:

1. Engage the brake pedal lock. If the tractor can be

pushed forward or rearward, the braking force

must be increased.

2. Release the brake pedal lock. If the tractor cannot

be pushed forward or rearward, the braking force

must be decreased.

To adjust the braking force proceed as follows (Refer

to Figure 12):

1. Place the tractor on a level surface with the brake

pedal lock disengaged. Stop the tractor engine

and remove the ignition key.

2. Working from the under right side of the tractor, at

the brake pedal shaft, locate the front threaded

end of the brake rod:

• Remove the internal cotter pin from the brake

rod adjustment ferrule and withdraw the ferrule

from the brake cam. See Figure 12.

• Loosen the hex flange insert lock nut from

against the ferrule.

To increase the braking force —

Turn the ferrule clockwise (inward) one full turn at

a time until the ferrule can be inserted into the

brake cam while applying a minimal tension on

the spring.

To decrease the braking force —

Turn the ferrule counterclockwise (outward) one

full turn at a time until the ferrule can be inserted

into the brake cam while applying a minimal

tension on the spring.

3. Turn the ferrule counterclockwise (outward) one

full turn to release the slight spring tension.

Tighten the hex flange insert lock nut against the

ferrule, then insert the ferrule into the brake cam

and secure with the internal cotter pin.

Figure 12

Recheck the brake adjustment to ensure proper brake

operation before operating the tractor. If brake rod

adjustment does not correct the problem, see your

authorized Cub Cadet dealer.

SEAT

ADJUSTMENT

LEVER

Move Lever

to Left

SPRING

BRAKE

INTERNAL

ADJUSTMENT

FERRULE

BRAKE

CAM

HEX FLANGE

Viewed from top (fender off)

COTTER PIN

ROD

INSERT LOCK NUT

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Cub-cadet GT-2550 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Cub-cadet GT-2550