Cub-cadet CLT-160 Manuel d'utilisateur télécharger pdf (Page 27)

• Remove both hairpin clips from the pin which is

fastened to the speed control assembly (be careful

not to lose the small flat washers found on the pin).

See Figure 29.

• Remove the drive pedal return spring.

• Using two 9/16" wrenches, remove the pin from the

speed control assembly. See Figure 29.

• Thread the idler adjustment rod inward or outward

to lengthen or shorten the travel of the double-idler

bracket until proper adjustment is achieved.

• Reassemble by following the above steps in

reverse order.

Figure 29

SECTION 14: OFF-SEASON STORAGE

If the machine is to be inoperative for a period longer

than 30 days, prepare for storage as follows.

WARNING: Never store the machine or

fuel container indoors where there is an open

flame, spark or pilot light such as on water

heater, furnace, clothes dryer or other gas

appliance.

WARNING: Use a fuel stabilizer additive or

drain the fuel into an approved container

outdoors, away from an open flame. Allow

engine to cool. Extinguish cigarettes, cigars,

pipes and other sources of ignition prior to

draining fuel.

• Clean the engine and the entire unit thoroughly.

• Lubricate all lubrication points. Wipe the entire

machine with an oiled rag to protect the painted

metal surfaces.

• Refer to the engine manual for correct engine

storage instructions. The engine must be

completely drained of fuel to prevent gum deposits

from forming on essential carburetor parts, fuel

lines and fuel tanks.

• It is not necessary to remove the battery from the

tractor for storage. However, clean the top of the

battery and make sure it has full charge. Disconnect

the negative terminal of the battery before storing

the tractor.

• Store unit in a clean, dry area.

NOTE: When storing any type of power equipment in

an unventilated or metal storage shed, care should be

taken to rustproof the equipment. Using a light oil or

silicone, coat the equipment, especially any chains,

springs, bearings and cables. attachments &

accessories.

Speed Control

Assembly

Hairpin

Clips

Idler

Adj. Rod

AutoDrive

™

Pedal

Return Spring

Place Wrenches Here

Neutral

Return

Bracket

1 2 ... 22 23 24 25 26 27 28 29

Commentaires sur ces manuels

Pas de commentaire

Cub-cadet CLT-160 Manuel d'utilisateur Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Machines spéciales Cub-cadet CLT-160