Cub Cadet CC3075 Manuel de l'opérateur Page 12

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 26
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 11
Section 6
Maintenance
MaintenanceSchedule
Perform these required maintenance procedures at the
frequency statedin the table, lhese procedures should
also be a part of any seasonal tune-up.
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about
these procedures take your unit to any non-
road engine repair establishment.
To prevent serious injury, never perform
maintenance or repairs with unit running. Always
service and repair a cool unit. Disconnect the spark
plug wire to ensure that the unit cannot start.
NOTE: Maintenance, replacement or repair of the
emission control devices and system may be
performed by any non-read engine repair
establishmen_ individual or authorized
service dealer.
In order to assure peak performance of your engine,
inspection of the engine exhaust port may be necessary
after 50 hours of operation. If you notice lost RPM, poor
performance or general lack of acceleration, this service
may be required, if you feel your engine is in need of this
inspection, refer service to any non-road engine repair
establishment, individual or authorized service dealer for
repair. DO NOT attempt to perform this process yourself
as engine damage may result from contaminants
involved in the cleaning process for the port.
Before s_a_ting engine Fiii _ei tank wi_ freSfi fUei Page8
Outer Spool
,_ .......... Spring
Inner Reel _._)_,
Bump Knob....... Bolt
Fig. 6-1
Line Installation
[his section covers both SptitLine TM and standard single
line installation.
Always use original equipment manufacturer 0.105 in.
(2.67 mm) replacement line. Using line other than the
specified may make the engine overheat or fail.
Never use metal-reinforced line, wire, chain or
rope. These can break off and become dangerous
projectiles.
There are two methods to replace the trimming line:
Wind the inner reeI with new tine
install a prewound inner reel
12iiiiii
Vue de la page 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 25 26

Commentaires sur ces manuels

Pas de commentaire