Cub Cadet 190-002 Manuel de l'opérateur télécharger pdf (Page 13)

Attaching the Hydraulic Pump Assembly

To mount the hydraulic pump assembly to the tractor,

make certain that it is placed under the center of the

tractor’s frame, resting on the ground, with the hydraulic

hoses attached. Connect the hydraulic pump assembly

as follows:

• The rear of the hydraulic pump assembly has a

“tongue” on it. The tongue is the flat portion toward

the rear of the assembly. Raise the rear of the

assembly up and slide the tongue into the slotted

portion of the rear mounting bracket. Refer to

Figure 13.

• Before raising the front of the hydraulic pump

assembly, remove the front hanger rod by removing

one of the hairpin clips and sliding the rod out.

• Lift the front of the hydraulic pump assembly and

align the holes in the assembly with the holes in the

side frame brackets.

• Install the front hanger rod and secure with the

hairpin clip removed earlier.

With the hydraulic pump assembly installed, locate the

sleeve that surrounds the two hydraulic hoses and slide

it toward the hydraulic pump as far as possible. This will

provide more protection to the hydraulic hoses where it

is necessary.

Installing the PTO Drive Belt

The hydraulic pump drive belt needs to be installed.

This belt connects the tractor’s PTO to the hydraulic

pump which provides power to the tiller attachment.

The following describes how the belt is installed:

• Raise the hood of the tractor and locate the PTO

pulley on the front of the engine.

• Working from the engine compartment, feed the

belt around the front of the PTO pulley and place

the last portion of the belt onto the pulley with the V-

groove of the belt facing into the pulley.

Figure 13

• Lying down on the right side of the tractor, take the

loose portion of the belt and pull it toward the back

of the tractor.

• Keeping light tension on the belt, align the V-groove

of the belt into both mule drive pulleys mounted

slightly in front of the front axle of the tractor. There

should be a single 90° twist of the belt between the

PTO pulley and each mule drive pulley.

• Place a 3/8” ratchet head, set to tighten, into the

square hole near the right hand idler pulley and

apply force. Notice how the pulley moves toward

the outside of the tractor. Doing this will make

installing the remainder of the belt easier.

• Making certain that the belt has a single 90° twist

between the mule drive pulleys and the idler

pulleys, and that the flat side of the belt is resting on

the idlers, apply pressure to the ratchet and finish

routing the belt around the hydraulic pump pulley.

Be sure that the V-groove of the belt is set

completely in the pulley before releasing the

ratchet.

• Recheck the routing of the belt to ensure that it is

resting completely in all the grooves of all the

pulleys before engaging the PTO.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet 190-002 Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Cub Cadet 190-002