Cub Cadet Sc Series Manuel de l'opérateur télécharger pdf (Page 11)

11Section 3 — ASSembly & Set-Up

2. Slide two hooks of side discharge chute under hinge pin on

mulching plug assembly. Lower the mulching plug. Do not

remove side mulching plug at any time, even when you are

not mulching.

Adjustments

Cutting Height

The rear wheel cutting height adjustment lever is located above

the rear left wheel. See Figure 3-10A insert.

Figure 3-10

1. Pull lever out and away from mower.

2. Move lever forward or back for desired cutting height.

3. Release lever towards mower deck.

The front wheel cutting height is determined by selecting one

of six positions on each caster assembly. To adjust front cutting

height, refer to Figure 3-10B and proceed as follows:

1. Remove wing nut from axle bolt. Slide axle bolt and wave

washer from the assembly and select a cutting height.

2. With wave washer on axle bolt, reinsert hardware in the

square hole desired through wheel assembly and secure

with wing nut previously removed.

IMPORTANT: All wheels must be placed in the same

relative position. For rough or uneven lawns, move the

height adjustment lever to a higher position. This will stop

scalping of grass.

The casters can be locked in a straight ahead position or

positioned to swivel freely. See Figure 3-10C insert.

1. Lift lock pins.

2. Place in larger holes to lock wheels. Place pins in smaller

holes to allow casters to rotate freely for turning.

2. Follow steps below to attach grass catcher:

a. Lift rear discharge door.

b. Place grass catcher into the slots in the handle

brackets as shown in Figure 3-8. Let go of discharge

door so that it rests on the grass catcher.

Figure 3-8

To remove grass catcher, lift rear discharge door on the mower.

Lift grass catcher up and off of the slots in the handle brackets.

Release rear discharge door to allow it to close rear opening of

mower.

Side Discharge Chute

Your mower is shipped as a mulcher. To convert to side discharge,

make sure grass catcher is off of the unit and rear discharge door

is closed.

1. On the side of the mower, lift the side mulching plug. See

Figure 3-9.

Side Mulching

Plug

Figure 3-9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet Sc Series Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Cub Cadet Sc Series