Cub Cadet 60 Fabricated Deck Manuel de service

Hydrostatic Zero-TurnCommercial Riding MowerProfessional Turf EquipmentOPERATOR’S AND SERVICE MANUAL60” Fabricated DeckW/ R.O.P.S.

10b. Avoid turning downhill if possible, if not use extra care and go slowly.c. Avoid turning when going downhill, traction is at a minimum going down

114.Electric Blade Clutch Switch: (See Figure 1.) Located on the right side of the mower beside the ignition switch. This is an “on/off” push pull swi

12C.Initial Adjustments1. Check the fluid levels and tires:Note: These checks should be made daily, before starting the engine.a. Fuel: Using a good g

13f. Raise the mowing deck to the transport position using the transport lever.g. Use the transport lever to lower the mow-ing deck to the cutting pos

143. Move both lap bars out of the neutral/start position to the neutral position (toward center of machine). Slowly, move both lap bars toward the fr

15Note: Do not hold the key in the “Start” position for more than 10 seconds or you may damage the starter. If the engine does not start in this time,

16MAINTENANCE ANDSERVICEWARNING:Disconnect the spark plug wires or remove the key from the ignition to prevent the engine from accidentally starting b

17a. Set the parking brake.b. Clean any debris from the blades. Keep blades sharp and free of build up at all times.c. Sharpen blades evenly at the or

181. Adding Hydraulic Oil (use SAE14W 40)a. Place the Mower on a level surface and engage the parking brake.b. Stop the engine and remove the key from

19c. Store the battery with a full charge. A dis-charged battery will freeze (refer to the table below).d. Recharge battery when ever the specific gra

2TABLE OF CONTENTSForeword. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

20occurs. Engage the BBC (PTO Clutch) a couple of times, and re-check the air-gap. If it is not between the specs listed on page 24, repeat the adjust

212.Leaking Tires: When a flat tire occurs, repair or replace immediately. The normal procedure is to remove the wheel and replace it with a spare. Ta

22pin from the clevis pin and pulling the clevis pin from the brake clevis. Loosen the hex nut and turn the brake clevis in a clockwise direction one

23tion the mower moves — to the front or the rear. To make the adjustment, place the steer-ing levers in the opened-out neutral position and set the p

24MAINTENANCE SCHEDULEA. Daily Checks1. Before starting engine:a. Check the fuel level.**b. Check the engine oil level.**c. Check the hydraulic oil le

25.OIL CHARTApply a few drops of engine oil or use a spray lubricant. Apply the oil to both sides of pivot points. Wipe off any excess. Start engine a

26Performance AdjustmentsA. High Speed Tracking AdjustmentIf mower tracks to one side with both lap bars in fully forward position:1. Check air pressu

27g. Verify proper throttle adjustment by check-ing RPM readings as outlined above.C. Deck Corner Ball Wheel Roller Settings1. Matching the set height

28F. Deck leveling Procedure1. Park the mower on a flat paved surface, engage the parking brake, shut off the engine, remove the key from the ignition

29WIRING DIAGRAMGD: 02000591

3FORWARDThe Tank Hydrostatic Zero-Turn Commercial Riding Mower provides superb maneuverability, mid-mount cutting capability for professional landscap

30MAINTENANCE RECORDDATE WORK PERFORMED DATE WORK PERFORMED

31

MANUFACTURER’S LIMITED WARRANTY - TURF EQUIPMENTThis warranty is specific to the product manual to which it is attached.For a complete list of product

4GENERAL SAFETYOPERATIONSA. DANGER1. Do not operate machine in confined areas where exhaust gases can accumulate.2. Do not operate machine without mow

511. When looking for oil leaks, never run your hand over hydraulic hoses, lines or fittings. Never tighten or adjust hydraulic hoses, lines or fittin

6blade bolts are tight before restarting the engine.13. Never leave the mower unattended without: turning off the blade clutch switch; placing the lef

7SAFETY DECALS AND LABELSK EEP HA ND S an d FE ET AW AYDANGERTO REDUCE THE RISK OF INJURY,DO NOT OPERATE MOWER UNLESSDI SCHARGE CHUTE COVER O R GRASS

8SPECIFICATIONSGENERAL INFO.Controls: Engine ignition and start switch; throttle; choke; left and right steering levers; electric blade clutch switch;

9OPERATING INSTRUCTIONSA.General1. When Mowing:a. Keep adults, children, and pets away from the area to be mowed.b. When operating this mower, in the