Cub Cadet 54-inch Manuel de l'opérateur télécharger pdf (Page 8)

SECTION II. INSTALLATION AND REMOVAL OF MOWER DECK

A. INSTALLATION OF DECK

After locking the left lift link as described in Section I

(step B-2), start the tractor and use the hydraulic lift to

fully raise the left lift link (See Figure 5). Stop engine.

Figure 5

Remove the internal cotter pins, flat washers, and ad-

justment clevis pins to adjust the front caster wheel

arms to their highest setting (lowest deck setting) in the

height adjustment brackets of the deck (See Figure 6).

Figure 6

Adjust the rear deck rollers to their highest setting (low-

est deck setting) as follows:

1. From the left/rear of the deck, pull the adjustment

knob rearward to disengage the detent pin of the

knob from the hole in the detent hub (See Figure

7). Hold the knob rearward.

2. Turn the knob clockwise until the shoulder bolt

fastened to the roller pivot link is at the top of the

slot in the roller guide bracket (See Figure 7).

3. Release the knob and turn as necessary to align

the detent pin with the nearest hole in the hub.

Figure 7

Install the mower deck on the tractor as follows:

1. Place the tractor and mower deck on a firm and

level surface. Position the mower deck on the left

side of the tractor with the front of the deck toward

the front of the tractor (See Figure 8)

Figure 8

LEFT LIFT LINK

FULLY RAISED

CASTER

WHEEL

ARM

HGT. ADJ.

BRACKET

ADJUSTMENT

TOP

HOLE

INTERNAL

COTTER PIN

FLAT

WASHER

CLEVIS PIN

SHOULDER BOLT

PIVOT LINK

ADJUSTMENT

KNOB

DETENT

HUB

GUIDE

BRACKET

SLOT

ROTATE

DETENT PIN

SLIDE

UNDER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet 54-inch Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Cub Cadet 54-inch