Cub Cadet 54-inch Manuel de l'opérateur télécharger pdf (Page 6)

SECTION I. TRACTOR AND DECK PREPARATION

WARNING

When handling the mower deck, be careful not

to cut yourself on the sharp blades.

Remove the top and break down the sides of the crate

to remove the deck assembly from the shipping

container. Cut the tie strap securing the front drive shaft

to the deck assembly. Remove all padding material from

the drive shafts. Refer to Figure 1.

NOTE: The mower deck front lift bracket/rod assembly

is shipped on the tractor. If not already done, cut the tie

strap securing the front lift bracket/rod assembly to the

front of the tractor frame. Pull the center of the tractor’s

quick latch rod downward to remove the lift bracket as-

sembly from the tractor.

Figure 1

NOTE: The chute deflector may have been factory in-

stalled. If so, skip to Step B.

A. DECK PREPARATION

WARNING

Never operate the mower deck without the chute

deflector installed and in the down position.

To aid in assembly, the chute deflector is shipped with

the torsion spring mounted and tie-strapped in place

(See Figure 2). Do not cut the tie strap until after the

chute deflector has been installed.

1. Mount the chute deflector on the right hand castor

channel hinge brackets, with the long end of the

spring flat against the top of the deck and pointing

toward the center of the deck (See Figure 2).

2. Insert the tapered end of the hinge pin into the

front mounting tab of the chute deflector. Then

drive the pin through the chute and hinge brack-

ets making sure it passes through the torsion

spring. DO NOT drive the pin fully into place now.

3. The torsion spring should hold the chute deflector

downward in the operating position. Lift the chute

deflector to check for spring tension. If very little

tension is felt, pull the hinge pin and load the

spring by turning the long end one turn in the

same direction as the spring coil windings.

Reinsert the hinge pin and drive completely into

the deflector

4. When the hinge pin is assembled correctly, the

end will be slightly past flush with the chute

deflector tab (See Figure 2). Cut and remove the

tie strap from the torsion spring.

Figure 2

LONG END

OF SPRING

TIE

STRAP

CASTER CHANNEL

HINGE PIN

TORSION

SPRING

HINGE BRKTS.

CHUTE

DEFLECTOR

TAB

DECK ASSEMBLY

CHUTE

DEFLECTOR

FRONT DRIVE

SHAFT

REAR DRIVE

SHAFT

FRONT LIFT BRKT/ROD ASS’Y.

— SHIPPED ON TRACTOR

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet 54-inch Manuel de l'opérateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Cub Cadet 54-inch