Cub Cadet CS 2210 Manuel d'utilisateur télécharger pdf (Page 9)

Controls and Features

Chipper Chute

Branches up to two inches (model series CS 2210) or three inches

(model series CS 3210) in diameter may be fed into the chipper

chute for chipping.

Hopper

Leaves, twigs, and branches up to 1/2-inch in diameter may be

placed into the hopper for shredding. See Fig. 4-1.

IMPORTANT: Never place branches with a diameter greater than

1/2-inch in the hopper. Doing so can result in serious damage to

your unit’s shredder blade, flails or impeller.

Tow Bar

Use the tow bar to tow the chipper shredder behind a tractor to

a job site.

Handle

Use the handle when manually transporting the chipper

shredder.



Recoil Starter

The recoil starter is located on the engine. Pull the recoil starter

to start engine.

Engine Controls

See the engine Owner/Operator manual packed with your unit

for the location and function of the controls on the engine.

Spring Latch (Model Series CS 3210 Only)

The spring latch is located on the top of the hopper. It is used to

release or lock the chipper chute in a raised position for storage

or for transporting. See Fig. 4-1.

Never operate the chipper shredder

with the chipper chute in the raised position. Use

the spring latch to lower the chipper chute into the

operating position before starting the engine.

Lock Rod (Model Series CS 3210 Only)

The lock rod is located on the chipper chute support. It is used

to release or lock the chipper chute in a lowered position for

operation.

e

e

Hopper

rter

ow B









1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet CS 2210 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Broyeurs pour jardin Cub Cadet CS 2210