Cub-cadet 526 WE Manuel d'utilisateur Page 22
- Page / 24
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Troubleshooting
7
22
Problem Cause Remedy
Engine fails to start Choke not in ON position.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
Faulty spark plug.
Blocked fuel line.
Safety key not in ignition on engine.
1.
2.
3.
4.
5.
6.
7.
Move choke to ON position.
Connect wire to spark plug.
Fill tank with clean, fresh gasoline.
Prime engine as instructed in “Operating
Your Snow Thrower”.
Clean, adjust gap, or replace.
Clean fuel line.
Insert key fully into the switch.
1.
2.
3.
4.
5.
6.
7.
Engine runs erratic Unit running on CHOKE.
Blocked fuel line or stale fuel.
Water or dirt in fuel system.
Carburetor out of adjustment.
1.
2.
3.
4.
Move choke lever to OFF position.
Clean fuel line; fill tank with clean, fresh
gasoline.
Drain fuel tank. Refill with fresh fuel.
Contact an authorized Service Center.
1.
2.
3.
4.
Engine overheats Carburetor not adjusted properly.1. Contact Service Center.1.
Excessive vibration Loose parts or damaged auger.1. 1. Stop engine immediately and disconnect
spark plug wire. Tighten all bolts and nuts. If
vibration continues, have unit serviced by an
authorized Service Center.
1.
Loss of power Spark plug wire loose.
Gas cap vent hole plugged.
Exhaust port plugged.
1.
2.
3.
Connect and tighten spark plug wire.
Remove ice and snow from gas cap. Be
certain vent hole is clear.
Contact Service Center.
1.
2.
3.
Unit fails to propel itself Drive control cable in need of adjustment.
Drive belt loose or damaged.
1.
2.
Adjust drive control cable. Refer to “Making
Adjustments”.
Replace drive belt.
1.
2.
Unit fails to discharge snow Chute assembly clogged.
Foreign object lodged in auger.
Auger control cable in need of adjustment.
Auger belt loose or damaged.
Shear pin(s) sheared.
1.
2.
3.
4.
5.
Stop engine immediately and disconnect
spark plug wire. Clean chute assembly and
inside of auger housing with clean-out tool
or a stick.
Stop engine immediately and disconnect
spark plug wire. Remove object from auger
with clean-out tool or a stick.
Refer to Auger Control Test.
Refer to Maintenance section.
Replace with new shear pin(s).
1.
2.
3.
4.
5.
Troubleshooting
8
22
- OperatOr’s Manual 1
- To The Owner 2
- Training 3
- Preparation 3
- CALIFORNIA PROPOSITION 65 3
- Assembly & Set-Up 6
- Shear Pins 7
- Auger Control 9
- Controls and Features 10
- Chute Directional Control 12
- Chute Clean-Out Tool 12
- Operation 13
- To Engage Drive 14
- To Engage Augers 14
- Replacing Shear Pins 14
- Maintenance & Adjustments 15
- Adjustments 16
- Off-Season Storage 17
- Belt Replacement 18
- Drive Belt 19
- Friction Wheel Removal 20
- 21sectiOn 7 — service 21
- Troubleshooting 22
- Replacement Parts 23
- CUB CADET LLC 24
- SNOW THROWERS 24
Produits connexes et manuels pour Voitures Cub-cadet 526 WE
Voitures Cub-cadet 421R Manuel d'utilisateur
(20 pages)
(20 pages)
Voitures Cub-cadet 721E Manuel d'utilisateur
(16 pages)
(16 pages)
Voitures Cub-cadet 521E Manuel d'utilisateur
(20 pages)
(20 pages)
Voitures Cub-cadet M467 Manuel d'utilisateur
(28 pages)
(28 pages)
Desa CGCFTN manuels
Manuels d'utilisation et guides de l'utilisateur pour Poêles Desa CGCFTN.
Nous fournissons des manuels en pdf 1 Desa CGCFTN à télécharger gratuitement par type de document : Manuel de l'utilisateur
Commentaires sur ces manuels