CUB CADET LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019Printed In USAOperatOr’s ManualSafe Operation Practices • Set-Up • Operation • Maintenance •
Snow thrower controls and features are described below and illustrated in Fig. 4-1. NOTE: For detailed information on all engine controls, refer to
Throttle ControlThe throttle control is located on the rear of the engine. It regulates the speed of the engine and will shut off the engine when move
Chute Directional ControlThe chute directional control is located on the left side of the dash panel.To change the direction in which snow is thrown,
Starting The EngineAttach spark plug wire to spark plug. Make certain the metal loop on the end of the spark plug wire (inside the rubber boot) is fas
To Engage DriveWith the throttle control in the Fast (rabbit) position, move shift lever into one of the six forward (F) positions or two reverse (R)
MaintenanceEngineRefer to the Tecumseh Engine manual packed with your machine for all engine maintenance.Shave Plate and Skid ShoesThe shave plate an
Auger ShaftAt least once a season, remove the shear pins from the auger shaft. Spray lubricant inside the shaft and around the spacers and the flange
Drive ControlWhen the drive control is released and in the disengaged “up” position, the cable should have very little slack. It should NOT be tight.
Belt ReplacementAuger BeltTo remove and replace your snow thrower’s auger belt, proceed as follows:To prevent spillage, place a piece of plastic wrap
Remove the belt from around the auger pulley, and slip the belt between the support bracket and the auger pulley. See Fig. 7-5.Reassemble auger belt
To The Owner12Record Product InformationBefore setting up and operating your new equipment, please locate the model plate on the equipment and record
Slip the drive belt off the pulley and between friction wheel and friction wheel disc. See Fig. 7-7.Remove and replace belt in the reverse order.NOTE:
Carefully remove the hex nut which secures the hex shaft to the snow thrower frame and lightly tap the shaft’s end to dislodge the ball bearing from t
Troubleshooting722Problem Cause RemedyEngine fails to start Choke not in ON position.Spark plug wire disconnected.Fuel tank empty or stale fuel.Engin
Component Part Number and Description929-0071 Extention Cord, 110V954-04050 Auger Drive Belt754-0367 Wheel Drive Belt684-04153 Friction Wheel Asse
The limited warranty set forth below is given by Cub Cadet LLC with respect to new merchandise purchased and used in the United States, its possession
Important Safe Operation Practices23TrainingRead, understand, and follow all instructions on the machine and in the manual(s) before attempting to ass
4 sectiOn 2 — iMpOrtant safe OperatiOn practicesSafe Handling of GasolineTo avoid personal injury or property damage use extreme care in handling gaso
5sectiOn 2 — iMpOrtant safe OperatiOn practicesMaintenance & StorageNever tamper with safety devices. Check their proper operation regularly. Refe
AssemblyHandlePlace the shift lever in the Forward-6 positionObserve the lower rear area of the snow thrower to be sure both cables are aligned with r
Finish securing chute control assembly to chute support bracket with wing nut and hex screw removed earlier. See See Fig. 3-4.Check that all cables a
Tire PressureBefore operating, check tire pressure and reduce pressure in both tires to between 15 psi and 20 psi. NOTE: If the tire pressure is not e
Auger ControlWARNING! Prior to operating your snow thrower, carefully read and follow all instructions below. Perform all adjustments to verify your
Commentaires sur ces manuels