Cub Cadet Z-Force 54-KH Manuel d'utilisateur télécharger pdf (Page 31)

31se c t i O n 7 — se r v i c e

Remove the blade drive belt from all the pulleys.4.

5.

proper belt routing.

6.

the idler pulley so that a ten-pound pull with a spring scale

between two pulleys deflects the belt about ⁄

Replacing the Blades

WARNING! 



the parking brake lever, turn the ignition key to the





handling the blades. When servicing the mower

deck, be careful not to cut yourself on the

sharpened blades.

Remove the key from the ignition and disconnect the spark 

plugs.

2.

block it in that position.

Wrap a rag around one end of the blade and grasp it to 

prevent it from turning, or secure the blade by placing a

block of wood between the blade and the deck housing.



4. ⁄

bolt.

5. ⁄

Remove the blade.6.

To replace the blade reverse the above process and tighten 7.



NOTE: Add a small amount of multi-purpose grease to the

bolt threads to avoid corrosion and galvenic action.

WARNING! 

that are bent should be replaced. The cutting blades

are sharp and can cause severe injury. Wrap the

cutting surface of the blade with a rag to avoid

injury.

Figure 7-5

Figure 7-6

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Pas de commentaire

Cub Cadet Z-Force 54-KH Manuel d'utilisateur Page 31