Cub Cadet 7532 Manuel de l'opérateur télécharger pdf (Page 78)

TIRES/WHEELS/SPACING/BALLAST

Toe-in Adjustment

TO CHECK THE TOE-IN, USE THE FOLLOWING PROCEDURE:

1. Put the tractor on level ground and the wheels in the straight-ahead

position.

2. Place chalk marks at points A on the centerlines of both front tires at

the same height as the centerline of the hubcap.

3. Measure the distance (L

1) between the chalk marks at points A.

4. Move the tractor forward a distance equal to one-half revolution of the

front wheels.

5. The chalk marks will now be at points B. Measure the distance (L

between the chalk marks at points B.

6. The figure of L

1 minus L2 is the toe-in. Make sure the toe-in is adjusted

properly. If not, adjust the toe-in.

FRONT AXLE TYPE

MFD

TURN THE WHEELS

ONE-HALF

REVOLUTION

TOE-IN (L

1-L2)

0 TO 0.20 INCH (0 TO 10 mm)

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 125 126

Pas de commentaire

Cub Cadet 7532 Manuel de l'opérateur Page 78