Cub Cadet 528 SWE Manuel de l'opérateur télécharger pdf (Page 8)

Finish securing chute control assembly to chute support 3.

bracket with wing nut and hex screw removed earlier.

See See Fig. 3-4.

Check that all cables are properly routed through the cable 4.

guide on top of the engine. See Fig. 3-5.

Figure 3-4

Set-Up

Shear Pins

A pair of replacement auger shear pins and bow tie cotter pins

are included with your snow thrower. Store them in your snow

thrower’s dash panel until needed. See Fig. 3-5.

Chute Clean-Out Tool

The chute clean-out tool is fastened to the top of the auger

housing with a mounting clip and a cable tie at the factory. Cut

the cable tie before operating the snow thrower. See Fig. 3-7.

Figure 3-6

Chute Clean-out Tool

Figure 3-7

Figure 3-5

8 se c t i O n 3— as s e M b l y & se t -up

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Cub Cadet 528 SWE Manuel de l'opérateur Page 8