Cub Cadet 80 LB Manuel de l'opérateur télécharger pdf (Page 13)

SECTION 4: SERVICING YOUR UTILITY VEHICLE

Lubrication

Front Axle Lubrication

• Lubricate one grease fitting on each axle with 2 or 3

shots of grease every 50 hours.

Engine

Read the engine operator’s manual for any service or

maintenance information pertaining to the engine.

Filling Fuel Tank

• Stop the vehicle on a level surface and apply

parking brake.

• Turn the ignition key to the STOP position and

remove the key.

• Allow engine to cool several minutes before you

add fuel.

• Clean area around fuel cap and remove cap.

See Figure 14.

• Fill tank with fresh, unleaded, regular grade fuel

only to bottom of filler neck. Use a minimum of 87

octane.

• After refueling, make sure tank cap is closed

securely.

Figure 14

Battery

WARNING: The battery produces a

flammable and explosive gas. Do not smoke

near battery. Wear eye protection and gloves

when handling the battery. Do not allow direct

metal contact across battery posts.

The battery is sealed and is maintenance-

free. Acid levels cannot be checked and fluid

can not be added.

IMPORTANT:

If removing the battery for any reason,

disconnect the NEGATIVE (Black) wire from it’s

terminal first, followed by the POSITIVE (Red) wire.

When re-installing the battery, always connect the

POSITIVE (Red) wire to its terminal first, followed by

the NEGATIVE (Black) wire. Be certain that the wires

are connected to the correct terminals; reversing them

could change the polarity and cause damage to your

engine’s alternating system.

Clean Battery and Terminals

• Remove battery from vehicle. Always remove

negative cable first when disconnecting.

• Wash battery with solution of four tablespoons of

baking soda to one gallon of water.

• Rinse the battery with plain water and dry.

• Clean terminals and battery cable ends with wire

brush until bright.

• Apply petroleum jelly or silicone spray to terminals

to prevent corrosion.

• Install battery. Always install negative cable last

when connecting.

Jumping a Battery

WARNING: Do not attempt to jump start a

frozen battery. Warm to 60 degrees F (16

degrees C). Do not smoke near battery and

wear eye protection and gloves when

handling battery.

• Connect positive (+) jumper cable to booster

battery positive (+) post (A). See Figure 15.

• Connect the other end of positive (+) jumper cable

to the disabled vehicle battery positive (+) post (B).

• Connect negative (-) jumper cable to booster

battery negative (-) post (C).

• Connect the other end (D) of negative (-) jumper

cable to a metal part of the disabled machine frame

away from battery.

• Start the engine of the disabled machine and run

machine for several minutes.

• Carefully disconnect the jumper cables in the exact

reverse order: negative cable first and then the

positive cable.

Figure 15

Charging

WARNING: Charge battery in a well

ventilated area and keep away from an open

flame or pilot light as on a water heater, space

heater, furnace, clothes dryer or other gas

appliances.

Fuel Cap

Disabled Battery

Booster Battery

Jumper Cables

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Cub Cadet 80 LB Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Diffuseur Cub Cadet 80 LB