13
Engaging 4x4 (4x4 Only)
The 4x4 switch is located on the right side of the dash
panel. See Know Your Utility Vehicle.
1. To engage, stop or slow vehicle speed and push
up on the switch. Front wheels will engage if rear
wheels are slipping.
IMPORTANT: Engage the 4x4 feature as the first option
when stuck in mud or similar situation where two wheel
drive is ineffective at moving vehicle.
2. If still unable to move vehicle with the 4x4 engaged,
engage the differential lock as described below.
Engaging Differential Lock
The differential lock lever is located in the center console
between the seats. See Know Your Utility Vehicle.
1. To engage, stop vehicle, place into Neutral, and
pull the lever rearward. The differential will then lock
and remain so until it is disengaged, giving continuous
power to both rear wheels.
IMPORTANT: Engage the differential as the last option
when stuck in mud or similar situation or when the left
and right side wheels are turning at slightly different
speeds.
WARNING: To avoid transmission
damage, injury, or turf damage, go slow
when operating vehicle with differential
lock engaged as steering response is
noticeably reduced. Also, do not drive the unit with the
differential lock engaged on concrete, asphalt or any
high traction surfaces.
Disengaging Differential Lock
1. To disengage the differential lock, stop the unit, place
in Neutral, and push the lever forward.
Raising & Lowering Cargo Box
WARNING: To prevent the possibility
of bodily injury from unintentional
lowering of the cargo box, be sure
vehicle is on a level and stable
surface and parking brake is locked before raising
cargo box.
Manual Lift
1. Park the vehicle safely on level ground and set
parking brake.
2. Empty cargo by hand and unlatch cargo box by
pulling up on the cargo latch.
3. While holding the latch down, lift the cargo box.
4. Lower and allow bed to re-latch cargo box before
operating unit.
Electric Lift (Optional)
1. Park the vehicle safely and turn key to the RUN
position.
2. Raise cargo box by pressing and holding top of
electric lift switch. Release switch when box is at
desired dump height or when maximum height is
reached.
NOTE: A ratcheting noise will indicate cargo box is at
full extension. The same noise will also be heard when
cargo box is at the full down position. If lift capacity
of the power lift is exceeded, a ratcheting will also be
heard.
3. To lower cargo box, push on bottom of electric lift
switch. Turn ignition switch to the STOP position.
Dumping Load
From Cargo Box
1. Back up the vehicle to the dump site and apply
parking brake.
2. Unlatch the tailgate from cargo box.
3. If using an electric lift, raise cargo box to dump load
and lower box when empty.
4
WARNING
Operating
Your
Utility
Vehicle
To avoid transmission
damage, injury, or
turf damage, go slow
when operating vehicle
with differential lock
engaged as steering
response is noticeably
reduced.
To prevent the possibil-
ity of bodily injury from
unintentional lowering
of the cargo box, be
sure vehicle is on a
level and stable sur-
face and parking brake
is locked before raising
cargo box.
Do not stop or start
suddenly when going
uphill or downhill. Be
especially cautious
when changing direc-
tion on slopes. Apply
brakes when going
down slopes to main-
tain control of vehicle.
(24 pages)
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels