Cub Cadet 721E Manuel de l'opérateur

Naviguer en ligne ou télécharger Manuel de l'opérateur pour Les souffleuses à neige Cub Cadet 721E. Cub Cadet 721E Operator`s manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Single Stage
Snow Thrower
Model 721E
PRINTED IN U.S.A.
Operator’s Manual
FORM NO
.
7/11/01
IMPORTANT: Read safety rules and instructions carefully before operating equipment.
770-10542
CUB CADET CORP. P.O. BOX 368023 CLEVELAND, OHIO 44136-9722
Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-
covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting
applicable local or state laws (if any). If a spark arrester is used, it should be maintained in effective working order by the operator.
In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have
similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized
service dealer or contact the service department, P.O. Box 368023 Cleveland, Ohio 44136-9722.
Vue de la page 0
1 2 3 4 5 6 ... 15 16

Résumé du contenu

Page 1 - Operator’s Manual

Single StageSnow ThrowerModel 721EPRINTED IN U.S.A.Operator’s ManualFORM NO. 7/11/01IMPORTANT: Read safety rules and instructions carefully before ope

Page 2 - CALLING CUSTOMER SUPPORT

10SECTION 6: MAINTAINING YOUR SNOW THROWERReplacing Belt• Remove the belt cover by removing five hex screws. See Figure 12.Figure 12• Pull up on the

Page 3 - Preparation

11SECTION 7: OFF-SEASON STORAGE• Clean snow thrower thoroughly.• Lubricate as instructed above with a light oil.• Follow “Storage” instructions in th

Page 4 - Maintenance And Storage

12SECTION 9: PARTS LIST FOR MODEL 721E159216621621420162414172338221013212560718111119125552627282930313233343536373839403341424344454647484950424951

Page 5

13Model 721ERef. No. Part No. Part Description1.684-0174 Upper Chute Crank Assemby2.684-0177 Lower Chute Crank Assembly3.684-0178 Bracket Assembly: Mi

Page 6 - Assembling Discharge Chute

14Model 721ERef. No. Part No. Description1.629-0236 Extension Cord2.710-0157 Hex Bolt 5/16-24 x 0.75”3.710-0409 Hex Bolt 5/16-24 x 1.75”4.710-0502A T

Page 7 - To Start Engine

15Model 721ERef. No. Part No. Description1.710-0487 Carriage Screw 5/16-18 x 2.0”2.710-1270 Machine Screw3.712-0324 Hex Lock Nut 1/4-204.720-0284 Han

Page 8 - Operating Tips

MANUFACTURER’S LIMITED WARRANTY FOR:TWO-YEAR RESIDENTIALONE-YEAR COMMERCIALProper maintenance of your Cub Cadet equipment is the owner’s responsibilit

Page 9 - Carburetor

2TABLE OF CONTENTSContent PageImportant Safe Operation Practices ... 3A

Page 10 - Lubrication

3SECTION 1: IMPORTANT SAFE OPERATION PRACTICESDANGER: This machine was built to be operated according to the rules for safe operation in this manual.

Page 11

44. Never operate with a missing or damaged discharge chute. Keep all safety devices in place and working.5. Never run an engine indoors or in a poorl

Page 12

5SECTION 2: ASSEMBLING YOUR SNOW THROWERUnpacking From Carton• Cut along corners of the carton and lay it down flat. Remove packing material. • Remov

Page 13 - Model 721E

6handle. Hold the “Z” fitting with the pliers, not the cable, to avoid damaging the cable.NOTE: The upper hole in the control handle providesfor adjus

Page 14

7Discharge Chute The angle of the discharge chute controls the distance that the snow is thrown. Tilt the discharge chute up for greater distance; til

Page 15

8• If you have a grounded three-prong receptacle, proceed as follows. • Rotate choke lever to FULL position.• Connect power cord to switch box on dash

Page 16

9SECTION 5: MAKING ADJUSTMENTSShave Plate • To check the adjustment of the shave plate, place the unit on a level surface. See Figure 8. The wheels,

Commentaires sur ces manuels

Pas de commentaire