Printed In USASafe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty WARNINGREAD AND FOLLOW ALL SAFETY
Snow thrower controls and features are described below and illustrated in Fig. 4-1. NOTE: For detailed information on all engine controls, refer to
Throttle ControlThe throttle control is located on the rear of the engine. It regulates the speed of the engine and will shut off the engine when move
Two-Way Chute Control™The two-way chute control is located on the left side of the dash panel and is used to control the distance of snow discharge fr
Starting The EngineAttach spark plug wire to spark plug. Make certain the metal loop on the end of the spark plug wire (inside the rubber boot) is fas
Operating TipsNOTE: Allow the engine to warm up for a few minutes. The engine will not develop full power until it reaches operating temperature.WARNI
Slide the shave plate out of the off-set slot at the bottom of the housing, and from between the skid shoes and side panels of the housing.With the mo
Auger ShaftAt least once a season, one at a time, remove the shear pins from the auger shaft. Spray lubricant inside the hub of each auger spiral ass
Drive ControlRefer to “Auger and Drive Control Cables” of the Assembly & Set-Up - Section 3 for instructions to adjust the drive control. To furth
Belt ReplacementBelt Removal PreparationDisconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washe
From both sides of the frame assembly, use a 1/2" wrench to remove the three hex tap screws securing the transmission frame to the auger housing
To The Owner12Record Product InformationBefore setting up and operating your new equipment, please locate the model plate on the equipment and record
To adjust, disconnect ferrule from brake bracket assembly. Thread ferrule in (towards idler) to increase tension on belt, or out to decrease belt tens
Place the belleville washer (rounded side toward head) onto the hex screw removed earlier, and insert the screw into the threaded hole of the hex shaf
22Problem Cause RemedyEngine fails to start Choke control not in ON position.Spark plug wire disconnected.Fuel tank empty or stale fuel.Engine not pri
Replacement Parts923Component DescriptionPart Number30 Inch 33 InchExtention Cord, 110V 929-0071 929-0071Auger Drive Belt 954-04131 954-0222AWheel Dri
The limited warranty set forth below is given by Cub Cadet LLC with respect to new merchandise purchased and used in the United States, its possession
Important Safe Operation Practices23TrainingRead, understand, and follow all instructions on the machine and in the manual(s) before attempting to ass
4 sectiOn 2 — iMpOrtant safe OperatiOn practicesSafe Handling of GasolineTo avoid personal injury or property damage use extreme care in handling gaso
5sectiOn 2 — iMpOrtant safe OperatiOn practicesMaintenance & StorageNever tamper with safety devices. Check their proper operation regularly. Refe
AssemblyIMPORTANT: Two replacement auger shear pins are included with this manual (or stowed in the plastic handle panel). Refer to the Maintenance se
Headlight HarnessIf not already done, wrap the wires of the headlight wire harness around the lower right handle; then attach the wires to the engine
While observing the distance between the shave plate and the ground, adjust the skids shoes up or down to achieve the desired shave plate height. See
Gas & Oil Fill-UpWARNING! Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the
Commentaires sur ces manuels